Phone Installation; Verify The Network Setup - Cisco 8832 Administration Manual

Phone Installation

•
•
•
•
•
•
•

Verify the Network Setup

As they deploy a new IP telephony system, system administrators and network administrators must complete
several initial configuration tasks to prepare the network for IP telephony service. For information and a
checklist for setting up and configuring a Cisco IP telephony network, see the documentation for your particular
Cisco Unified Communications Manager release.
For the phone to operate successfully as an endpoint in your network, your network must meet specific
requirements. One requirement is the appropriate bandwidth. The phones require more bandwidth than the
recommended 32 kbps when they register to Cisco Unified Communications Manager. Consider this higher
bandwidth requirement when you configure your QoS bandwidth. For more information, refer to Cisco
Collaboration System 12.x Solution Reference Network Designs (SRND) or later (
en/us/td/docs/voice_ip_comm/cucm/srnd/collab12/collab12.html
Note The phone displays the date and time from Cisco Unified Communications Manager. The time displayed on
the phone can differ from the Cisco Unified Communications Manager time by up to 10 seconds.
Procedure
Step 1 Configure a VoIP Network to meet the following requirements:
• VoIP is configured on your routers and gateways.
• Cisco Unified Communications Manager is installed in your network and is configured to handle call
Verify the Network Setup, on page 25
Enable Autoregistration for Phones, on page 26
Daisy Chain Mode, on page 27
Install the Conference Phone, on page 28
Set Up the Phone from the Setup Menus, on page 36
Enable Wireless LAN from the Phone, on page 42
Verify the Phone Startup, on page 48
processing.
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
4
C H A P T E R
https://www.cisco.com/c/
).
25