Set Up The Wireless Lan From Cisco Unified Communications Manager - Cisco 8832 Administration Manual

Cisco IP Conference Phone Installation
Step 3
Press On.

Set Up the Wireless LAN from Cisco Unified Communications Manager

In Cisco Unified Communications Manager Administration, you must enable a parameter called "Wi-Fi" for
the conference phone.
Note
In the Phone Configuration window in Cisco Unified Communications Manager Administration (Device >
Phone), use the wired-line MAC address when you configure the MAC address. Cisco Unified Communications
Manager registration does not use the wireless MAC address.
Perform the following procedure in Cisco Unified Communications Manager Administration.
Procedure
Step 1 To enable the wireless LAN on a specific phone, perform the following steps:
a) Select Device > Phone.
b) Locate the required phone.
c) Select the Enabled setting for the Wi-Fi parameter in the Product Specific Configuration Layout section.
d) Check the Override Common Settings check box.
Step 2 To enable wireless LAN for a group of phones,
a) Select Device > Device Settings > Common Phone Profile.
b) Select the Enabled setting for the Wi-Fi parameter.
Note
c) Check the Override Common Settings check box.
d) Associate the phones with that common phone profile using Device > Phone.
Step 3 To enable wireless LAN for all WLAN-capable phones in your network,
a) Select System > Enterprise Phone Configuration.
b) Select the Enabled setting for the Wi-Fi parameter.
Note
c) Check the Override Common Settings check box.
To ensure that the configuration in this step works, uncheck the Override Common Settings
check box mentioned in Step 1d.
To ensure that the configuration in this step works, uncheck the Override Common Settings
check box mentioned in Step 1d and Step 2c.
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
Set Up the Wireless LAN from Cisco Unified Communications Manager
43