Cisco Unified Communications Manager Phone Installation; Set Up A Cisco Ip Conference Phone - Cisco 8832 Administration Manual

Cisco Unified Communications Manager Phone
Installation
•
•
•
•
•
•
•

Set up a Cisco IP Conference Phone

If autoregistration is not enabled and the phone does not exist in the Cisco Unified Communications Manager
database, you must manually configure the Cisco IP Phone in Cisco Unified Communications Manager
Administration. Some tasks in this procedure are optional, depending on your system and user needs.
For more information on any of the steps, see the documentation for your particular Cisco Unified
Communications Manager release.
Perform the configuration steps in the following procedure using Cisco Unified Communications Manager
Administration.
Procedure
Step 1 Gather the following information about the phone:
• Phone model
• MAC address: see
• Physical location of the phone
• Name or user ID of phone user
• Device pool
• Partition, calling search space, and location information
Set up a Cisco IP Conference Phone, on page 51
Determine the Phone MAC Address, on page 55
Phone Addition Methods, on page 56
Add Users to Cisco Unified Communications Manager, on page 57
Add a User to an End User Group, on page 59
Associate Phones with Users , on page 59
Survivable Remote Site Telephony, on page 60
Determine the Phone MAC Address, on page 55
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
5
C H A P T E R
51