Install Usb Drivers; Set Up Usb Lan On Pc; Cisco Unified Wireless Ip Phone 7925G, 7925G-Ex, And 7926G Administration Guide - Cisco 7925G Administration Manual

Install USB Drivers

• Windows XP 32 bit
• Windows 7 32 bit
• Windows 7 64 bit
Related Topics
Backup Settings Area, on page 105
Install USB Drivers
To install the drivers on your PC, perform the following steps.
Procedure
Step 1 Log in to Cisco.com.
Step 2 Download the installation package and read me file for the USB drivers from this location:
http://www.cisco.com/cgi-bin/tablebuild.pl/ip-7900ser-crypto
Note
Step 3
Double-click on the USB installation file (listed in the read me file) to start the installation program.
Step 4 Follow the prompts in the InstallShield Wizard.
Note
Step 5 When you see the Finished screen, the installation is complete. Close the wizard.
Step 6 Plug the USB cable into the USB port on the PC and into the USB connector on the phone.
The Found New Hardware Wizard dialog box opens.
Step 7 To update the new software, click the button next to Yes, this time only and click Next.
Step 8 Click the button next to Install the Software automatically (Recommended).
After 2 to 3 minutes, the software installs and a message appears on the task bar stating Found New
Hardware - Software installed and ready to use.
Step 9 Click Finish when the installation completes.
The phone briefly displays USB Connected on the status line.

Set Up USB LAN on PC

To configure the USB LAN connection on your PC, follow these steps:

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide

68
Before proceeding, review the read me file for specific instructions for your PC operating system.
If you receive a Hardware Installation warning message stating that the software has not passed
Microsoft Windows Logo testing, click Continue.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages