Wavelink Settings Fields - Cisco 7925G Administration Manual

Wavelink Settings Fields

Item
Network Services Level
Security Level
User Interface Level
Wireless Level
Audio Level
System Level
Wavelink Settings Fields
You can configure Wavelink settings from the phone CU. The following table describes the Wavelink settings.
Table 33: Wavelink settings
Setting
Enable
Use Alternate Server
Alternate Server
Custom Name 1-4
Custom Value 1-4
Update Phone
When you have completed the phone configuration changes, you must export the configuration file from the
phone CU to Wavelink, and then update the phone.
Note The CU does not perform a complete validation of the phone configuration. If the configuration file
contains an invalid setting, the phone may reject the configuration and send an error message to the syslog.
To update the phone with the updated configuration file, perform the following steps.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
144
Description
DHCP, TFTP, CDP data.
Application level security data.
Key strokes, softkeys, MMI data.
Channel scanning, authentication data.
RTP, SRTP, RTCP, DSP data.
Firmware, upgrade data.
Description
Enables the Wavelink server.
Enables the use of alternate Wavelink server.
If the User Alternate Server is enabled, enter an IP address for the alternate
server.
Assign up to four attribute names to the phone to be used as selection
criteria.
Define the values for each Custom Name to be used as selection criteria.
Wavelink Avalanche Server