Set Up Wavelink Server Address From Phone Web - Cisco 7925G Administration Manual

Wavelink Avalanche Server
Procedure
Step 1 Turn on the phone.
Step 2 Verify that the phone is installed with the required firmware version and is registered to Cisco Unified
Communications Manager.
Step 3 Choose SETTINGS > System Configuration > Wavelink.
Step 4 To unlock the phone, press **#.
Step 5 In the Alternate Wavelink Server option, choose Yes.
Step 6
Enter the IP address of the Wavelink server, and press Save.
Set Up Wavelink Server Address from Phone Web Page
To assign the Wavelink server using the phone web page, follow these steps.
Procedure
Step 1 From the phone web page, choose Wavelink Settings from the left pane.
Under Wavelink Settings, make sure that the server is enabled.
Step 2
Click Use the following Server and enter the IP address of the server.
Step 3 Click Save.
Set Up and Use CU
This section describes the tasks for configuring and using the CU from the Wavelink Management Console.
Note The CU is labeled as 7921G but the CU works for all 792X phones.
To set up and use the CU from the Wavelink Management Console, perform the following tasks.
Procedure
Step 1
Assign attributes for the phone. For more information, see
Step 2 Install the CU on Wavelink. For more information, see
Step 3 Update the configuration files. For more information, see
Step 4 Update the phones. For more information, see
Install CU File, on page
Phone Attributes Setup, on page
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
Set Up Wavelink Server Address from Phone Web Page
Phone Attributes Setup, on page
137.
Update Configuration Files, on page
136.
136.
137.
135