Ring Volume Is Too Low - Cisco 7925G Administration Manual

Ring Volume is Too Low

Solution
Use the following list to identify possible causes for the problem:
• Check the access point to see if the transmit power setting matches the transmit power setting on the
• Check that the access point is enabled for ARP caching. When the phone is in power save mode or
• Check your gateway and IP routing for voice problems.
• Check if a firewall or NAT is in the path of the RTP packets. If so, you can use Cisco IOS and PIXNAT
• Check that the Data Rate setting for the phone and the access point are the same. These settings should
• Check the phone hardware to be sure the speaker is functioning properly.
• Check the volume settings in the Phone Settings menu.
• Check that the speaker is functioning properly. Adjust the speaker volume setting and call the phone to
Related Topics
Site Survey Verification, on page 44
Ring Volume is Too Low
Problem
User complains that the ringer on the phone is not loud enough.
Solution
To see if the ring volume is set correctly on the phone, choose Settings > Phone Settings > Sound Settings
> Volumes. Scroll up for the highest volume.
You can also press the Volume button on the side of the phone and the volume setting appears on the phone
screen.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
218
phone. One-way audio is common when the access point power setting is greater than that of the phone.
The phone firmware supports dynamic transmit power control (DTPC). The phone uses the transmit
power that the access point advertises upon association.
With DTPC, if Client Transmit Power is set in the access point, the phone automatically
Note
uses the same client power setting. If the access point is set for the maximum setting
(Max), the access point uses the Transmit Power setting on the phone.
scanning, the access point can respond to the wireless IP phone only when ARP caching is enabled.
to modify the connections so that two-way audio is possible.
match or the phone should be set for Auto.
check the speaker.
Troubleshooting