Site Survey Report - Cisco 7925G Administration Manual

Site Survey Report

Trace Logs, on page 105
Upgrade Phone Firmware, on page 108
Backup Settings Area, on page 105
Site Survey Report
Before the Site Survey Report is generated for viewing from the phone web page, you must first run the Site
Survey utility from the phone. For more information, see
To view the report, go to the phone web page and choose Site Survey from the left pane. An HTML report
in the form of a neighbor table of Access Points (AP) displays.
You can also run the Neighbor List utility from the phone to display a list of current APs on the phone.
Note
However, this utility will not generate the Site Survey Report that you can access from the phone web
page. See also
The neighbor table provides a matrix of APs observed during the site survey. Depending on the extent of the
survey, not all observed APs will be considered a best AP or an immediate neighbor.
The Site Survey Report stores information about each AP until it reaches a limit of 256 APs. For each AP,
up to ten neighbors are tracked.
The following table shows the information shown in the site survey report.
Table 24: Site Survey Report Neighbor Table
Information
Report title
Best AP
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
110
Display Neighbor List, on page
Description or indicator
The Service Set Identifier (SSID) used during Site Survey is displayed in the
report title.
Information displayed in cell with yellow background and where the row
heading matches the column heading (for example, 64%-60/-43):
• Percentage of time it is the best AP.
• Received Signal Strength Indicator (RSSI) range during the time it is
the best AP.
Note A low number (below -65) may indicate insufficient overlap between
the best AP and its neighbors.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Perform Site Survey, on page
45.
46.