Network Configuration Fields When Dhcp Not In Use - Cisco 7925G Administration Manual

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Procedure
Step 1 Choose the network profile that you want to configure.
Step 2 Under the IP Network Configuration area, choose Use the following IP addresses and DNS servers.
Step 3 Enter the required IP addresses. See
descriptions of these fields.
Step 4 Click Save to make the change.

Network Configuration Fields When DHCP Not in Use

When DHCP is not in use, the fields listed in the following table need to be statically configured.
Table 21: Network Configuration fields
Static setting
IP Address
Subnet Mask
Default Router 1
DNS Server 1
DNS Server 2
TFTP Server 1
TFTP Server 2
Domain Name
Set Up Alternate TFTP Server
If you use DHCP to direct the phones to a TFTP server, you can also assign an alternative TFTP server to
some phones instead of the one assigned by DHCP.
Note If you disable DHCP, then you must use these steps to set up the TFTP server for the phone.
To assign an alternate TFTP server to a phone, follow these steps:
Network Configuration Fields When DHCP Not in Use, on page 93
Description
IP address of the phone
Subnet mask used by the phone
Primary gateway used by the phone
Primary DNS server used by the phone
Optional backup DNS server used by the phone
Primary TFTP server used by the phone
Optional backup TFTP server used by the phone
Name of the DNS in which the phone resides
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
Set Up Alternate TFTP Server
93
for