Change USB Port Setup
•
To obtain an IP address automatically from the PC, choose Enable, then press Save. You have completed
the USB configuration.
• To use a static IP address, choose Disable, then press Save.
Note
Note
Step 5
To change the static IP address, scroll to IP Address, and press Select.
Step 6
Enter a new IP address that is not assigned on the subnet.
Step 7
To save the changes, press Options > Save.
Step 8
To change the subnet for the new IP address, scroll to Subnet Mask and press Select.
Step 9
Enter the appropriate subnet address.
Step 10 To save the changes, press Save.
Related Topics
Access Settings Menu, on page 115
Network Profile Settings, on page 116
Set Up Phone Security Certificate, on page 130
Phone Settings Menu, on page 127
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
132
If you disabled DHCP, you must enter an IP address and a subnet mask by performing Steps 5 through
12.
Do not perform the following steps if DHCP is
enabled.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Settings