Honeywell Thor VM1 Reference Manual page 112

Message
Hook wndproc of open
app failure
Hot key event creation
failure
Hot key pressed
Hot key pressed
Hot key set event failure
Hotkey press message
received
In app hook:WM_SIZE
In app hook:WM_WIN-
DOWPOSCHANGED
Initializing keyboard
hook procedure
Keyboard hook initial-
ization failure
Keyboard hook loaded
OK
L after Ctrl
Loading keyboard hook
Open failure
Open registry failure
Opened status file
Out of memory for
encrypted pwd
pRealTaskbarWndProc
already set
Pwd cancelled or invalid-
remain in user mode
Read registry error-hot
key
Read registry failure-app
name
Read registry failure-
Cmd Line
Read registry failure-Inter-
net
3-50
Explanation and/or corrective action
The application is open, but AppLock cannot lock it.
The Admin applet is unable to create the hotkey notification.
Processing the hotkey and backdoor entry
Processing the hotkey and backdoor entry
When the administrator changes the hotkey configuration the hotkey controller must be
notified. This notification failed.
The user just pressed the configured hotkey.
In addition to preventing the locked application from exiting, AppLock must also prevent
the application from enabling the taskbar and resizing the application's window. This mes-
sage traps a change in the window size and corrects it.
In addition to preventing the locked application from exiting, AppLock must also prevent
the application from enabling the taskbar and resizing the application's window. This mes-
sage traps a change in the window position and corrects it.
AppLock is calling the keyboard hook initialization.
The keyboard filter initialization failed.
The keyboard hook dll exists and loaded successfully.
Processing the backdoor entry.
When AppLock first loads, it loads a dll that contains the keyboard hook processing. This
message is logged prior to the load attempt.
The status information is being saved to a file and the file open has failed. This could
occur if the file is write protected. If the file does not exist, it is created.
If the Administration registry key does not exist, the switch to user mode fails because the
AppName value in the Administration key is not available.
The status information is being saved to a file and the file has been opened successfully.
Not enough memory to encrypt the password.
The taskbar control has already been installed.
The password prompt was cancelled by the user or the maximum number of failed
attempts to enter a password was exceeded.
The hotkey registry entry is missing or empty. This is not considered an error. The key-
board hook uses an embedded default if the value is not set in the registry.
AppName registry value does not exist or is empty. This constitutes a failure for switching
into user mode.
AppCommandLine registry entry is missing or empty. This is not considered an error
since command line information is not necessary to launch and lock the application.
The Internet registry entry is missing or empty. This is not considered an error since the
Internet value is not necessary to launch and lock the application.
Level
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_ERROR
LOG_PROC-
ESSING
LOG_EX
LOG_EX
LOG_PROC-
ESSING
LOG_ERROR
LOG_EX
LOG_EX
LOG_PROC-
ESSING
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR