Enabling And Disabling Logging - Cisco FirePOWER ASA 5500 series Configuration Manual

Configuring and Managing Logs

Enabling and Disabling Logging

This section describes how to enable and disable logging on the security appliance. It includes the
following sections:
•
•
•
Enabling Logging to All Configured Output Destinations
The following command enables logging; however, you must also specify at least one output destination
so that you can view or save the logged messages. If you do not specify an output destination, the security
appliance does not save system log messages generated when events occur.
For more information about configuring log output destinations, see the
Destinations" section on page
To enable logging, enter the following command:
hostname(config)# logging enable
Disabling Logging to All Configured Output Destinations
To disable all logging to all configured log output destinations, enter the following command:
hostname(config)# no logging enable
Viewing the Log Configuration
To view the running log configuration, enter the following command:
hostname(config)# show logging
The output of the show logging command is similar to the following:
Syslog logging: enabled
Cisco Security Appliance Command Line Configuration Guide
42-6
Enabling Logging to All Configured Output Destinations, page 42-6
Disabling Logging to All Configured Output Destinations, page 42-6
Viewing the Log Configuration, page 42-6
Facility: 16
Timestamp logging: disabled
Standby logging: disabled
Deny Conn when Queue Full: disabled
Console logging: disabled
Monitor logging: disabled
Buffer logging: disabled
Trap logging: level errors, facility 16, 3607 messages logged
Logging to infrastructure 10.1.2.3
History logging: disabled
Device ID: 'inside' interface IP address "10.1.1.1"
Mail logging: disabled
ASDM logging: disabled
42-7.
Chapter 42 Monitoring the Security Appliance
"Configuring Log Output
OL-10088-01