Cisco FirePOWER ASA 5500 series Configuration Manual page 117

Chapter 7 Configuring Interface Parameters
Configuring the Interface
For single context mode, or for interfaces that are not shared in multiple context mode, you might want
to assign unique MAC addresses to subinterfaces. For example, your service provider might perform
access control based on the MAC address.
To enable the interface, if it is not already enabled, enter the following command:
Step 7
hostname(config-if)# no shutdown
To disable the interface, enter the shutdown command. If you enter the shutdown command for a
physical interface, you also shut down all subinterfaces. If you shut down an interface in the system
execution space, then that interface is shut down in all contexts that share it, even though the context
configurations show the interface as enabled.
The following example configures parameters for the physical interface in single mode:
hostname(config)# interface gigabitethernet0/1
hostname(config-if)# speed 1000
hostname(config-if)# duplex full
hostname(config-if)# nameif inside
hostname(config-if)# security-level 100
hostname(config-if)# ip address 10.1.1.1 255.255.255.0
hostname(config-if)# no shutdown
The following example configures parameters for a subinterface in single mode:
hostname(config)# interface gigabitethernet0/1.1
hostname(config-subif)# vlan 101
hostname(config-subif)# nameif dmz1
hostname(config-subif)# security-level 50
hostname(config-subif)# ip address 10.1.2.1 255.255.255.0
hostname(config-subif)# mac-address 000C.F142.4CDE standby 020C.F142.4CDE
hostname(config-subif)# no shutdown
The following example configures interface parameters in multiple context mode for the system
configuration, and allocates the gigabitethernet 0/1.1 subinterface to contextA:
hostname(config)# interface gigabitethernet0/1
hostname(config-if)# speed 1000
hostname(config-if)# duplex full
hostname(config-if)# no shutdown
hostname(config-if)# interface gigabitethernet0/1.1
hostname(config-subif)# vlan 101
hostname(config-subif)# no shutdown
hostname(config-subif)# context contextA
hostname(config-ctx)# ...
hostname(config-ctx)# allocate-interface gigabitethernet0/1.1
The following example configures parameters in multiple context mode for the context configuration:
hostname/contextA(config)# interface gigabitethernet0/1.1
hostname/contextA(config-if)# nameif inside
hostname/contextA(config-if)# security-level 100
hostname/contextA(config-if)# ip address 10.1.2.1 255.255.255.0
hostname/contextA(config-if)# mac-address 030C.F142.4CDE standby 040C.F142.4CDE
hostname/contextA(config-if)# no shutdown
Cisco Security Appliance Command Line Configuration Guide
7-5
OL-10088-01