Example 6: Ipv6 Configuration - Cisco FirePOWER ASA 5500 series Configuration Manual

Example 6: IPv6 Configuration

ssl trust-point CA-MS inside
Finally, configure the email proxy settings.
Step 8
imap4s
enable outside
enable inside
enable dmz161
default-group-policy DfltGrpPolicy
pop3s
enable outside
enable inside
enable dmz161
default-group-policy DfltGrpPolicy
smtps
enable outside
enable inside
enable dmz161
default-group-policy DfltGrpPolicy
Example 6: IPv6 Configuration
This sample configuration shows several features of IPv6 support on the security appliance:
•
•
•
•
•
•
Cisco Security Appliance Command Line Configuration Guide
B-18
Each interface is configured with both IPv6 and IPv4 addresses.
The IPv6 default route is set with the ipv6 route command.
An IPv6 access list is applied to the outside interface.
The enforcement of Modified-EUI64 format interface identifiers in the IPv6 addresses of hosts on
the inside interface.
The outside interface suppresses router advertisement messages.
An IPv6 static route.
Appendix B Sample Configurations
OL-10088-01