Default Inspection Policy - Cisco FirePOWER ASA 5500 series Configuration Manual

Chapter 25 Configuring Application Layer Protocol Inspection
•
•

Default Inspection Policy

By default, the configuration includes a policy that matches all default application inspection traffic and
applies inspection to the traffic on all interfaces (a global policy). Default application inspection traffic
includes traffic to the default ports for each protocol. You can only apply one global policy, so if you
want to alter the global policy, for example, to apply inspection to non-standard ports, or to add
inspections that are not enabled by default, you need to either edit the default policy or disable it and
apply a new one.
Table 25-1
inspection engines that are on by default, shown in bold. This table also notes any NAT limitations.
Table 25-1 Supported Application Inspection Engines
1
Application Default Port NAT Limitations
CTIQBE TCP/2748
DNS over UDP UDP/53
FTP TCP/21
GTP UDP/3386
UDP/2123
H.323 H.225 and TCP/1720
RAS UDP/1718
UDP (RAS)
1718-1719
HTTP TCP/80
ICMP —
ICMP ERROR —
ILS (LDAP) TCP/389
MGCP UDP/2427,
2727
NetBIOS Name UDP/137,
Server over IP 138 (Source
ports)
PPTP TCP/1723
OL-10088-01
State information for multimedia sessions that require inspection are not passed over the state link
for stateful failover. The exception is GTP, which is replicated over the state link.
Some inspection engines do not support PAT, NAT, outside NAT, or NAT between same security
interfaces. See "Default Inspection Policy"
lists all inspections supported, the default ports used in the default class map, and the
—
No NAT support is available for
name resolution through
WINS.
—
—
No NAT on same security
interfaces.
No static PAT.
—
—
—
No PAT.
—
—
—
for more information about NAT support.
2
Standards Comments
— —
RFC 1123 No PTR records are changed.
RFC 959 —
— Requires a special license.
ITU-T H.323, —
H.245, H225.0,
Q.931, Q.932
RFC 2616 Beware of MTU limitations stripping
ActiveX and Java. If the MTU is too
small to allow the Java or ActiveX tag to
be included in one packet, stripping
may not occur.
— All ICMP traffic is matched in the
default class map.
— All ICMP traffic is matched in the
default class map.
— —
RFC 2705bis-05 —
— NetBIOS is supported by performing
NAT of the packets for NBNS UDP port
137 and NBDS UDP port 138.
RFC 2637 —
Cisco Security Appliance Command Line Configuration Guide
Inspection Engine Overview
25-3