Defining Route Maps - Cisco FirePOWER ASA 5500 series Configuration Manual

Defining Route Maps

Defining Route Maps
Route maps are used when redistributing routes into an OSPF or RIP routing process. They are also used
when generating a default route into an OSPF routing process. A route map defines which of the routes
from the specified routing protocol are allowed to be redistributed into the target routing process.
To define a route map, perform the following steps:
To create a route map entry, enter the following command:
Step 1
hostname(config)# route-map name {permit | deny} [sequence_number]
Route map entries are read in order. You can identify the order using the sequence_number option, or
the security appliance uses the order in which you add the entries.
Enter one or more match commands:
Step 2
•
•
•
•
•
•
Enter one or more set commands.
Step 3
Cisco Security Appliance Command Line Configuration Guide
9-6
You must use the setroute argument with the ip address pppoe command to obtain the default route
using PPPoE. Make sure the administrative distance is greater than the administrative distance of
the tracked route.
To match any routes that have a destination network that matches a standard ACL, enter the
following command:
hostname(config-route-map)# match ip address acl_id [acl_id] [...]
If you specify more than one ACL, then the route can match any of the ACLs.
To match any routes that have a specified metric, enter the following command:
hostname(config-route-map)# match metric metric_value
The metric_value can be from 0 to 4294967295.
To match any routes that have a next hop router address that matches a standard ACL, enter the
following command:
hostname(config-route-map)# match ip next-hop acl_id [acl_id] [...]
If you specify more than one ACL, then the route can match any of the ACLs.
To match any routes with the specified next hop interface, enter the following command:
hostname(config-route-map)# match interface if_name
If you specify more than one interface, then the route can match either interface.
To match any routes that have been advertised by routers that match a standard ACL, enter the
following command:
hostname(config-route-map)# match ip route-source acl_id [acl_id] [...]
If you specify more than one ACL, then the route can match any of the ACLs.
To match the route type, enter the following command:
hostname(config-route-map)# match route-type {internal | external [type-1 | type-2]}
Chapter 9 Configuring IP Routing
OL-10088-01