Default Interface Configuration - Cisco FirePOWER ASA 5500 series Configuration Manual

Chapter 4 Configuring Switch Ports and VLAN Interfaces for the Cisco ASA 5505 Adaptive Security Appliance
Figure 4-1
with Base License
With the Security Plus license, you can configure three VLAN interfaces for normal traffic, one VLAN
interface for failover, and one VLAN interface as a backup link to your ISP. This backup interface does
not pass through traffic unless the route through the primary interface fails.
The ASA 5505 adaptive security appliance supports Active/Standby failover, but not Stateful failover.
Note
See
Figure 4-2
with Security Plus

Default Interface Configuration

If your adaptive security appliance includes the default factory configuration, your interfaces are
configured as follows:
OL-10088-01
ASA 5505 Adaptive Security Appliance with Base License
Internet
ASA 5505
Business
Figure 4-2 for an example network.
ASA 5505 Adaptive Security Appliance with Security Plus License
ASA 5505
License
Home
Backup ISP
Primary ISP
DMZ
Failover Link
Inside
Cisco Security Appliance Command Line Configuration Guide
Interface Overview
Failover
ASA 5505
4-3