Displaying Object Groups - Cisco FirePOWER ASA 5500 series Configuration Manual

Adding Remarks to Access Lists

Displaying Object Groups

To display a list of the currently configured object groups, enter the following command:
hostname(config)# show object-group [protocol | network | service | icmp-type | id grp_id]
If you enter the command without any parameters, the system displays all configured object groups.
The following is sample output from the show object-group command:
hostname# show object-group
object-group network ftp_servers
description: This is a group of FTP servers
network-object host 209.165.201.3
network-object host 209.165.201.4
object-group network TrustedHosts
network-object host 209.165.201.1
network-object 192.168.1.0 255.255.255.0
group-object ftp_servers
Removing Object Groups
To remove an object group, enter one of the following commands.
You cannot remove an object group or make an object group empty if it is used in an access list.
Note
•
•
Adding Remarks to Access Lists
You can include remarks about entries in any access list, including extended, EtherType, and standard
access lists. The remarks make the access list easier to understand.
To add a remark after the last access-list command you entered, enter the following command:
hostname(config)# access-list access_list_name remark text
If you enter the remark before any access-list command, then the remark is the first line in the access list.
If you delete an access list using the no access-list access_list_name command, then all the remarks are
also removed.
The text can be up to 100 characters in length. You can enter leading spaces at the beginning of the text.
Trailing spaces are ignored.
For example, you can add remarks before each ACE, and the remark appears in the access list in this
location. Entering a dash (-) at the beginning of the remark helps set it apart from ACEs.
hostname(config)# access-list OUT remark - this is the inside admin address
hostname(config)# access-list OUT extended permit ip host 209.168.200.3 any
Cisco Security Appliance Command Line Configuration Guide
16-16
To remove a specific object group, enter the following command:
hostname(config)# no object-group grp_id
To remove all object groups of the specified type, enter the following command:
hostname(config)# clear object-group [protocol | network | services | icmp-type]
If you do not enter a type, all object groups are removed.
Chapter 16 Identifying Traffic with Access Lists
OL-10088-01