Xcommand Cameras Speakertrack Whiteboard Setdistance; Xcommand Cameras Speakertrack Whiteboard Storeposition; Conference Commands; Xcommand Conference Donotdisturb Activate - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xCommand Cameras SpeakerTrack Whiteboard SetDistance

Set the cameras distance to the whiteboard. This information is needed by the camera to frame
the whiteboard automatically.
Requires user role: ADMIN, USER
USAGE:
xCommand Cameras SpeakerTrack Whiteboard SetDistance Distance:
[WhiteboardId: WhiteboardId]
where
Distance: Integer (0..65534)
Set distance to whiteboard in centimeters. Use an accurate measurement for the
feature to work seamlessly.
WhiteboardId: Integer (1..8)
The id set for the camera position used for the snap-to-whiteboard feature. Currently
only id 1 can be used. The default is set to 1.

xCommand Cameras SpeakerTrack Whiteboard StorePosition

Store the position of the specified camera as the Snap to Whiteboard position. Frame the image
so that there is room around the whiteboard for the speaker. To use the Snap to Whiteboard
feature it must be enabled with xConfiguration Cameras SpeakerTrack Whiteboard Mode and
tracking must be enabled with xConfiguration Cameras SpeakerTrack Mode.
Note: You must store a snap-to-whiteboard position for both cameras.
Requires user role: ADMIN, USER
USAGE:
xCommand Cameras SpeakerTrack Whiteboard StorePosition CameraId:
[WhiteboardId: WhiteboardId]
where
CameraId: Integer(1..7)
The ID of the camera that is being positioned.
WhiteboardId: Integer (1..8)
You can give the position an id number. Currently the only id that can be used is 1. The
default is set to 1.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration
Distance
CameraId
xCommand xCommand

Conference commands

xCommand Conference DoNotDisturb Activate

This command switches on the Do Not Disturb mode, and the Timeout parameter allows you to
control when it is switched off again. When Do Not Disturb is switched on, all incoming calls are
rejected and registered as missed calls. The calling side receives a busy signal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Activate [Timeout: Timeout]
where
Timeout: Integer (1..1440)
Set the number of minutes before Do Not Disturb is switched off. If not set, Do Not
Disturb times out after 1440 minutes (24 hours).

xCommand Conference DoNotDisturb Deactivate

Switch off the Do Not Disturb mode. When Do Not Disturb is switched off incoming calls come
through as normal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Deactivate

xCommand Conference SpeakerLock Release

Releases locked speaker set by xCommand Conference SpeakerLock Set. Default voice
switching is switched back on.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Release
131
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.