Table of Contents
Advertisement
DIODE
ELECTRIC STARTER
FUNCTION INSPECTION
Disconnect the negative
(-)
cable from the battery
' S-T-A-R-T-E-R--------------'
(page
21 -6).
RELAY SWITCH
Disconnect the starter relay switch 2P green connec-
tor.
Remove the battery (+) cable and starter motor
cable from the starter relay.
Connect the fully charged 12 V battery positive (+)
terminal to the Yellow/red wire terminal and nega-
tive
(-)
terminal to the Light green/red wire terminal
of the starter relay switch side connector.
There should be continuity between
t
he cable termi-
nals while the battery is connected, and no continu-
ity when the battery is disconnected.
INSPECTION
Open the front hood.
Remove the 2P diode from the wire harness.
Check for continuity between the diode terminals.
When there is continuity, a small resistance value
will register.
If there is continuity in one direction, the diode is
normal.
Remove the battery box cover (page 21-6).
Remove the fuse box cover and the 3P diode from
the fuse box.
1+1
1'----';
H
1--_
12 V SA TTERY
23-13
Advertisement
Table of Contents
Troubleshooting
