Steering System Service Information; Steering System Specifications; Steering System Torque Values; Steering System Tools - Honda MUV700 big red Service Manual

STEERING SYSTEM
SERVICE INFORMATION
GENERAL
• A jack or other support is required to support the vehicle (page 1-48).
• Do not disassemble the steering column . Replace the column as an assembly when it is faulty.
• Use Honda Genuine replacement bolts and nuts for all joint and mounti ng poi nts.
• Adjust toe whenever the knuckle o r steering gear box components are replaced or removed (page 4-27) .
• For knuckle and wheel hub service, see Front WheefiSuspension section (page 15-2),
SPECIFICATIONS
ITEM
STANDARD SERVICE LIMIT
Steering wheel Rotational play
o
~ 10 mm (0 - 2/5 in)
Initial turning load 13.7 N (1.4 kgf, 3.1Ibf)
Wheel turning radius angle Inward: 40°, Outward: 33° (reference)
Toe
Toe-in: 0
±
10 mm (0 ± 2/5 in)
TORQUE VALUES
Steering whee! nut
Steering column mounting bolt
Steering shaft pinch bolt
Tie-rod joint nut
Rack end joint
Steering gear box mounting nut
Final gear case mounting nut
Final clutch arm cover base bolt
TOOLS
Ball joint remover, 28 mm
07MAC-SL00200
Lock nut clinch pilot
07NAZ-SR30100
49 N 'm (5.0 kgf·m, 36Ibf·ft)
27 N 'm (2.8 kgf·m , 20 Ibf·ft)
27 N'm (2.8 kgf·m , 20 Ibf·ft)
49 N 'm (5.0 kgf·m. 36Ibf·ft )
54 N'm (5.5 kgf·m, 40 Ibf·ft)
39 N'm (4.0 kgf·m, 29Ibf·ft)
54 N'm (5.5 kgf·m , 40 Ibf·ft)
10 N' m ( 1.0 kgf·m , 7 Ibf.ft)
Driver, 22 mm 1.0.
07746-0020100
c.
Aloe bolt: replace with a new one
Castle nut: tighten to the specified torque and further
tighten until its grooves aligns with the cotter pin hole.
lock nut: rep lace with a new one
Lock nut: rep lace with a new one
Base collar
07GAJ-PG20120
16-3