Honda MUV700 big red Service Manual page 253

CYLINDER HEADIVALVE/CAMSHAFT
Install the dowel pins and a new gasket. PUSH RODS
Install the push rods in the cam followers and fest . . .
!I! . . . . . . .
~---"".:;;~::;~~:..=:3
them on the gasket cu t out as sh own.
Apply engine oil to the rocker arm followers and
adjusting screw tips.
Installmg the head
Install the cylinder head cover while holding the
cover incorrectly
rocker arms that align the rocker arm f ollowers with
will result in severe
the push rod ends.
engine damage Do
Be sure to seat the rocker arm followers to the push
nor lighten the
rods properly by turning the crankshaft slowly.
head cover
fasteners when the
rocker arm are not
alIgned with /he
push rod end.
Apply engine oil to the cap nut threads and seating
surfaces and install the following fasteners.
- four washers and cap nuts
- three new washers and seven bolts
Tighten the nuts and bolts (including the cyl inder
and cylinder head bolts) in a crisscross pattern in
several st eps.
TORQUE: Cap nut: 65 N'm (6.6 kgf·m , 48 Ibf.ft)
Install the mounting rubbe rs on the upper engine
hanger bushing with the large I.D. side facing in.
Install the uppe r engine hanger bracket and the
three bolts and nut.
Tighten the two hanger bracket bolts.
TORQUE: 32 N 'm (3.3 kgf·m, 24 Ibl·ft)
Tighten the hanger nut.
TORQUE: 54 N 'm (5.5 kgf·m , 40 Ibf·ft)
Check the valve clearance (page 4- 11).
Tighten the following components if they were
removed.
TORQUE:
Spark plug: 22 N'm (2.2 kgf·m , 16Ibf·ft)
EeT sensor: 12 N·m (1.2 kgf·m , 9Ibf·ft)
NUTS ~ A~ N~D' ;:::~~~
_ _ HEAD
CO'.; V.:; E.; R ~
..
"'l
9-23