Belt/Retractor; Retractor Function Check - Honda MUV700 big red Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
BELT/RETRACTOR
Unlock the cargo bed by pull ing up on the release
lever and then raise the bed.
Remove t he following:
- anchor cover (by slid ing it down)
- upper and lower anthor bolt (16 mm head)
- retractor bolt (washer-bolt)
- seat belt assembly
Route the belt
Installation is in the reverse order of removal.
behmd the OPS as
shown.
NOTE:
• Sefore installing, check that the retractor locking
mechanism functions, see below.
• Assemble the washers of the anchor bolt prop-
erly if it was disassembled.
• When installing the retractor, align the locating
pin with the hole in the frame.
• When installing the anchor bolts, make sure
there no twists or kinks in the belt.
TORQUE: 32 N ·m (3.3 kgf·m , 24 Ibf.ft)
After installing, check the following:
- the belt does not lock when pulled slowly and it
will retra ct automatically when released . The
seat belt is designed to lock only during a sudden
stop.
- each anchor for free movement on the anchor
bolt. If necessary. remove the anchor bolt and
check that the washers and other pans are not
damaged or imprope rly installed .
RETRACTOR FUNCTION CHECK
Before installing the retractor, ch eck that the seat
belt can be pulled out freely within the parameters
mentioned below.
The sea t belt should not lock until the retractor is
tilted by 85° forward or backward or 55° left and
right. Do not attempt to disassemble the retractor.
ANCHOR BOLT
1=:;"",=1
SEAT
B~ E~ L T~o=
COVER
I
RETRACZ
I
ANCHOR BOLT
Upper Anchor;
A~)~.
'i1.
LOCK / / j
,,\ Q (]
WASHER ""'-
WAVE WASHER PLASTIC WASHER
Lower Anchor:
LOCK
~~
..
WAS HER '"'" / : ;
"'-...
,~"-
f '
~
WAVE WASHER PLASTIC WASHERS
Mounted position
55°<0>""
Right •
. Left
85°
(-1
---~--
B5°
Front • Rear
3-23