Half Shaft Bearing Replacement - Honda MUV700 big red Service Manual

FRONT DRIVING MECHANISM
HALF SHAFT BEARING
REPLACEMENT
Drive the bearing out of the housing.
Drive a new bearing into the housing with the mark-
ing facing up.
TOOLS:
Driver
Attachment, 62 x 68 mm
Pilot, 35 mm
ASSEMBLY
07749-0010000
07746-0010500
07746·0040800
PILOT
ATIACHMENT
OILSEAL ~
DIFFE RENTIAL LOCK
(
O,/~~
ARM SHAFT
~
)
@.
BEARING IS007)
SHIFT FORK
STOPPER ARM
--~~, ~
, FORK SPRING
Apply grease t o the lips of a new oi l seal and install
it
into the ctutch housing until
it
is fully seated.
Apply grease to the lock arm shaft outer surface
(fork and housing contacting surface).
Install the arm shaft, bei ng careful not to damage
the oil seal, then insta l the shift fork with the bolt
hole facing up.
Install the fork spring and stopper arm and set the
shaft end into the pivot hole i n the housing so the
spring end rest onto the
spr ing pin on the stopper
arm as shown.
Apply locking agent to the threads of the stopper
arm bolt.
Align the bolt holes with the shaft arm facing down,
then install the arm bol t with the washer and tighten
it.
TORQUE: 20 N'm (2.0 kgf·m , 14 Ibf.ft)
ARM
SHAFT
SPRING
WAS HE R AND
BOLT 0
....
STOPPER
ARM
19-25