Userinterface Settings; Userinterface Accessibility Incomingcallnotification; Userinterface Branding Awakebranding Colors; Userinterface Contactinfo Type - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

UserInterface settings

UserInterface Accessibility IncomingCallNotification

You can enable an incoming call notification with amplified visuals. The screen and Touch
10 will flash red/white approximately once every second (1.75 Hz) to make it easier for
hearing impaired users to notice an incoming call. If the system is already in a call the
screen will not flash as this will disturb the on-going call, instead you will get a normal
notification on screen and touch panel.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: Default
Value space: AmplifiedVisuals/Default
AmplifiedVisuals: Enable the amplified visuals on screen and touch panel when the video
system receives a call.
Default: Enable the default behavior with a notification on screen and touch panel.

UserInterface Branding AwakeBranding Colors

If the video system is set up with branding customizations, this setting affects the colors of
the logo that is shown when the video system is awake. You can choose whether you want
to show the logo in full color, or reduce the opacity of the logo so that it blends in more
naturally with the background and other elements on the screen.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/Native
Auto: The opacity of the logo is reduced.
Native: The logo has full colors.
D15330.14 SX10 Administrator Guide CE9.7, APRIL 2019.
Configuration Peripherals Maintenance

UserInterface ContactInfo Type

Choose which type of contact information to show in the user interface.
Requires user role: ADMIN
Default value: Auto
Value space: Auto/DisplayName/E164Alias/H320Number/H323Id/IPv4/IPv6/None/SipUri/
SystemName
Auto: Show the address which another system should dial to reach this video system.
The address depends on the default call protocol and system registration.
None: Do not show any contact information.
IPv4: Show the system's IPv4 address.
IPv6: Show the system's IPv6 address.
H323Id: Show the system's H.323 ID (refer to the H323 H323Alias ID setting).
H320Number: Show the system's H.320 number as contact information (only supported
if used with Cisco TelePresence ISDN Link).
E164Alias: Show the system's H.323 E164 Alias as contact information (refer to the H323
H323Alias E164 setting).
SipUri: Show the system's SIP URI (refer to the SIP URI setting).
SystemName: Show the system's name (refer to the SystemUnit Name setting).
DisplayName: Show the system's display name (refer to the SIP DisplayName setting).

UserInterface CustomMessage

A custom message can be displayed, in the lower left side of the screen, in awake mode.
Requires user role: ADMIN, INTEGRATOR
Default value: ""
Value space: String (0, 128)
Add a custom message. Add an empty string to remove a custom message.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
147
Administrator Guide
System settings System settings Appendices