Out Of Service - GE 869 Instruction Manual

CHAPTER 3: INTERFACES
NOTE:

Out of Service

Flash Messages
Label Removal
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
3.To disable Link Error Primary target when not in-use with SE order code, change IP
address to 127.0.0.1
Table 3-9: Major Self-test Errors
Self-test Error Latched
Message Target
Message
Relay Not No
Ready
Major Self-Test Yes
(error code)
When a total loss of power is present, the Critical Failure Relay (Output Relay 8) is de-
energized.
When the relay is shipped from the factory, the DEVICE IN SERVICE is set to "Not Ready".
The IN SERVICE LED will be orange and the critical fail relay will be de-energized but this will
not be classified as a major self-test. An out of service event will be generated in the event
recorder.
Flash messages are warning, error, or general information messages displayed in response
to pressing certain keys. The factory default flash message time is 2 seconds.
The following procedure describes how to use the label removal tool.
1. Bend the tabs of the tool upwards as shown in the image.
Description of How Often the Test
Problem is Performed
PRODUCT SETUP On power up and
INSTALLATION whenever the
setting indicates PRODUCT SETUP
relay is not in a INSTALLATION
programmed state. setting is altered.
Unit hardware failure Every 1 second
detected
FRONT CONTROL PANEL INTERFACE
What to do
Program all required
settings and then set the
PRODUCT SETUP
INSTALLATION setting to
"Ready".
Contact the factory and
supply the failure code as
noted on the display.
3–15