Cisco Catalyst 4500 series Administration Manual page 575

Chapter 16 Configuring VLANs, VTP, and VMPS
Switch(config)# vmps server 172.20.128.179 primary
Switch(config)# vmps server 172.20.128.178
Switch(config)# end
You can configure up to four VMPS servers using this CLI on the VMPS client.
Note
Switch# show vmps
VQP Client Status:
--------------------
VMPS VQP Version:
Reconfirm Interval: 60 min
Server Retry Count: 3
VMPS domain server: 172.20.128.179 (primary, current)
Reconfirmation status
---------------------
VMPS Action:
Configuring Dynamic Access Ports on a VMPS Client
To configure a dynamic access port on a VMPS client switch, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# interface interface
Step 3
Switch(config-if)# switchport mode
access
Step 4
Switch(config-if)# switchport access
vlan dynamic
Step 5
Switch(config-if)# end
Step 6
Switch# show interface interface
switchport
This example shows how to configure a dynamic access port and to verify the entry:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fa1/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan dynamic
Switch(config-if)# end
Switch# show interface fa1/1 switchport
Name: Fa0/1
Switchport: Enabled
Administrative mode: dynamic auto
Operational Mode: dynamic access
Administrative Trunking Encapsulation: isl
Operational Trunking Encapsulation: isl
Negotiation of Trunking: Disabled
Access Mode VLAN: 0 ((Inactive))
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: NONE
Pruning VLANs Enabled: NONE
OL_28731-01
1
172.20.128.178
No Dynamic Port
Purpose
Enters global configuration mode.
Enters interface configuration mode and specifies the port to be
configured.
Sets the port to access mode.
Configures the port as eligible for dynamic VLAN access.
Returns to privileged EXEC mode.
Verifies the entry.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
VLAN Membership Policy Server
16-25