Cisco-Phone - Cisco Catalyst 4500 series Administration Manual

Chapter 20 Configuring SmartPort Macros
Interface
--------------------------------------------------------------
Fa2/9
--------------------------------------------------------------

cisco-phone

This example shows how to use the system-defined macro cisco-phone to assign a value of 35 to the
access VLAN and 56 to the voice VLAN on the Fast Ethernet interface 2/9.
This macro requires the $AVID and $VVID keywords, which are the access and voice VLANs of the
Note
port.
Switch(config)# interface fastethernet2/9
Switch(config-if)# macro apply cisco-phone
Switch(config-if)# macro description cisco-phone $AVID 35 $VVID 56
Switch(config-if)# end
Switch# show parser macro name cisco-phone
Macro name : cisco-phone
Macro type : customizable
# VoIP enabled interface - Enable data VLAN
# and voice VLAN (VVID)
# Recommended value for access vlan (AVID) should not be 1\
switchport access vlan $AVID [access_vlan_id]
switchport mode access
# Update the Voice VLAN (VVID) value which should be
# different from data VLAN
# Recommended value for voice vlan (VVID) should not be 1
switchport voice vlan $VVID [voice_vlan_id]
# Enable port security limiting port to a 2 MAC
# addressess -- One for desktop and one for phone
switchport port-security
switchport port-security maximum 2
# Ensure port-security age is greater than one minute
# and use inactivity timer
switchport port-security violation restrict
switchport port-security aging time 2
switchport port-security aging type inactivity
# Enable auto-qos to extend trust to attached Cisco phone
auto qos voip cisco-phone
# Configure port as an edge network port
spanning-tree portfast
spanning-tree bpduguard enable@
Switch# show parser macro description
Interface
--------------------------------------------------------------
Fa2/9
--------------------------------------------------------------
cisco-switch
This example shows how to use the system-defined macro cisco-switch to assign a value of 38 to the
native VLAN on the Fast Ethernet interface 2/9.
OL_28731-01
Macro Description
cisco-desktop
Macro Description
cisco-phone
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
Configuring SmartPort Macros
20-11