Administering And Monitoring The Vmps - Cisco Catalyst 4500 series Administration Manual

Chapter 16 Configuring VLANs, VTP, and VMPS
Configuring the Retry Interval
You can set the number of times that the VMPS client attempts to contact the VMPS before querying the
next server.
To configure the retry interval, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# vmps retry count
Step 3
Switch(config)# end
Step 4
Switch# show vmps
This example shows how to change the retry count to 5 and to verify the change:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# vmps retry 5
Switch(config)# end
Switch# show vmps
VQP Client Status:
--------------------
VMPS VQP Version:
Reconfirm Interval: 60 min
Server Retry Count: 5
VMPS domain server: 172.20.130.50 (primary, current)
Reconfirmation status
---------------------
VMPS Action:

Administering and Monitoring the VMPS

You can display the following information about the VMPS with the show vmps command:
VQP Version
Reconfirm Interval
Server Retry Count
OL_28731-01
Purpose
Enters global configuration mode.
Specifies the retry count for the VPQ queries. Default is 3. Range is
from 1 to 10.
Returns to privileged EXEC mode.
Verifies the retry count.
1
No Host
The version of VQP used to communicate with the VMPS. The
switch queries the VMPS using VQP Version 1.
The number of minutes the switch waits before reconfirming the
VLAN-to-MAC-address assignments.
The number of times VQP resends a query to the VMPS. If no
response is received after this many tries, the switch starts to
query the secondary VMPS.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
VLAN Membership Policy Server
16-27