Chapter 5
Configuring Virtual Switching Systems
To convert the peer switch to standalone, perform this task on the VSS Standby switch:
Command
Switch-2# switch convert mode stand-alone
Configuring VSS Parameters
These sections describe how to configure VSS parameters:
•
•
•
•
•
•
Configuring VSL Switch Priority
To configure the switch priority, perform this task:
Command
Step 1
Switch(config)# switch virtual domain 100
OL-30933-01
Configuring VSL Switch Priority, page 5-41
Configuring a VSL, page 5-43
Adding and Deleting a VSL Port After the Bootup, page 5-43
Displaying VSL Information, page 5-44
Configuring VSL QoS, page 5-45
Configuring the Router MAC Address, page 5-46
Purpose
Converts Switch 2 to standalone mode.
After you enter the command, you are prompted to
confirm the action. Enter yes.
Purpose
Enters configuration mode for the virtual switch
domain.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)SG
Configuring a VSS
5-41