Switch# Show Issu State Detail; Slot = 6; Rp State = Active; Issu State = Init - Cisco Catalyst 4500 series Administration Manual

How to Perform the ISSU Process
*Feb 25 20:41:03.639: %INSTALLER-7-ISSU_OP_SUCC:
'issu runversion'
Note
......
......
Look at the console of new active supervisor engine.
*Feb 25 20:47:39.859: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)
*Feb 25 20:47:39.971: %INSTALLER-7-ISSU_OP_SUCC:
'issu commitversion'
.....
.....
Note
*Feb 25 20:54:16.092: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync succeeded
*Feb 25 20:54:16.094: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)
Switch#

Switch# show issu state detail

Switch# show redundancy
Redundant System Information :
------------------------------
Switchovers system experienced = 0
Configured Redundancy Mode = Stateful Switchover
Operating Redundancy Mode = Stateful Switchover
Current Processor Information :
------------------------------
Software Configuration Guide—Release IOS XE 3.6.0SG and IOS 15.2(2)SG
7-32
Switchover occurs.
The new standby supervisor engine reloads with target image; changeversion is successful upon
SSO terminal state is reached.

RP State = Active

ISSU State = Init

Operating Mode = Stateful Switchover

Current Image = bootflash:y.bin
Pre-ISSU (Original) Image = N/A
Post-ISSU (Targeted) Image = N/A
RP State = Standby
ISSU State = Init
Operating Mode = Stateful Switchover
Current Image = bootflash:y.bin
Pre-ISSU (Original) Image = N/A
Post-ISSU (Targeted) Image = N/A
Available system uptime = 12 minutes
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Maintenance Mode = Disabled
Communications = Up
Active Location = slot 6
Chapter 7 Configuring the Cisco IOS XE In Service Software Upgrade Process
issu changeversion successfully executed
issu changeversion is now executing

Slot = 6

Slot = 5
OL-30933-01