Cisco Catalyst 4500 series Administration Manual page 364

How to Perform the ISSU Process
•
•
•
Perform the following steps at the active supervisor engine:
Command or Action
Step 1
Switch> enable
Step 2
Switch# issu loadversion
active-image-new [standby-slot]
standby-image-new [forced]
Step 3
Switch# show issu state [detail]
Step 4
Switch# show redundancy [states]
This example shows how to start the ISSU process, boot the standby supervisor engine in the Standby
Hot state, and load the standby supervisor engine slot (6) with the new IOS XE software image:
Switch> enable
Switch# issu loadversion 5 bootflash:new_image 6 slavebootflash:new_image
%issu loadversion executed successfully, Standby is being reloaded
Switch# show issu state detail
Software Configuration Guide—Release IOS XE 3.6.0SG and IOS 15.2(2)SG
7-22
Optionally, perform additional tests and commands to determine the current state of peers and
interfaces for later comparison.
Ensure the system (both active and standby supervisor engines) is in SSO redundancy mode. If the
system is in RPR mode, you can still upgrade the system using the ISSU CLI commands, but the
system will experience extended packet loss during the upgrade.'
Refer to the Stateful Switchover document for more details on how to configure SSO mode on
supervisor engines.
For ISSU to function, the IOS XE file names on the active and standby supervisor engines must
match.
[
active-slot]
Chapter 7 Configuring the Cisco IOS XE In Service Software Upgrade Process
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Starts the ISSU process and (optionally) overrides the
automatic rollback when the new Cisco IOS XE software
version is detected to be incompatible.
It may take several minutes after entering the issu
loadversion command for Cisco IOS XE software to load
onto the standby supervisor engine and for the standby
supervisor engine to transition to SSO mode. This causes
the standby supervisor engine to reload with the new
software image.
If you use the forced option, the standby supervisor engine
is booted with the new software image. After the software
image is loaded on the standby supervisor engine, if the
software image is incompatible, the system is forced to the
RPR mode. Otherwise the system will continue in the SSO
mode.
Displays the state of ISSU during the ISSU process. At this
point in the ISSU process, use this command to check that
the standby supervisor engine is loaded and is in SSO mode.
It may take several minutes after entering the
issu loadversion command for Cisco IOS XE software to
load onto the standby supervisor engine and the standby
supervisor engine to transition to SSO mode. If you enter
the show issu state command too quickly, you may not see
the information you need.
Displays redundancy facility state information.
Slot = 5
RP State = Active
OL-30933-01