Configuring The Catalyst 4500 Series Switch With Cisco Network Assistant - Cisco Catalyst 4500 series Administration Manual

Configuring the Catalyst 4500 Series Switch with
Cisco Network Assistant
This chapter describes how to install Network Assistant on the workstation and configure the Catalyst
4500 (or 4900) series switch to communicate with Network Assistant. (The term Catalyst 4500 series
switch will be used to refer to both switch types in this chapter.) It also describes how to create
communities and clusters, which are two technologies used by Network Assistant to manage a group of
network devices, including the Catalyst 4500 series switch.
For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Note
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
This chapter contains these topics:
About Network Assistant, page 15-2
•
Network Assistant-Related Parameters and Their Defaults, page 15-3
•
Network Assistant CLI Commands, page 15-3
•
Configuring Your Switch for Network Assistant, page 15-4
•
Managing a Network Using Community, page 15-6
•
Converting a Cluster into a Community, page 15-10
•
Managing a Network Using Cluster, page 15-11
•
Configuring Network Assistant in Community or Cluster Mode, page 15-13
•
Note The Network Assistant is not bundled with an online software image on Cisco.com. You can download
the Network Assistant at this location:
http://www.cisco.com/en/US/products/ps5931/index.html
OL_28731-01
C H A P T E R
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
15
15-1