Issu Using The Four-Command Sequence: Step 2 (Runversion) - Cisco Catalyst 4500 series Administration Manual

In-Service Software Upgrade (ISSU) on a VSS
%issu loadversion executed successfully, Standby is being reloaded
Switch# show issu state detail
Switch# show redundancy states
Redundancy Mode (Operational) = Stateful Switchover
Redundancy Mode (Configured) = Stateful Switchover
Communications = Up
client_notification_TMR = 240000 milliseconds

ISSU using the Four-command Sequence: Step 2 (runversion)

This task describes the second step of the ISSU four-command sequence, runversion, wherein a
switchover occurs and the standby supervisor engine, which is now loaded with the post-upgrade image,
takes over as the new Active.
At the end of the loadversion step, the following message is logged:
*Aug 14 13:07:08.240: %INSTALLER-7-ISSU_OP_SUCC: Peer state is [STANDBY SSO]; Please issue
the runversion command
Now, you are ready to proceed to the next step.
Perform the following steps at the active supervisor engine.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)SG
5-68
RP State = Active
ISSU State = Load Version
Operating Mode = Stateful Switchover
Current Image = bootflash:old_image
Pre-ISSU (Original) Image = bootflash:old_image
Post-ISSU (Targeted) Image = bootflash:new_image
RP State = Standby
ISSU State = Load Version
Operating Mode = Stateful Switchover
Current Image = bootflash:new_image
Pre-ISSU (Original) Image = bootflash:old_image
Post-ISSU (Targeted) Image = bootflash:new_image
my state = 13 -ACTIVE
peer state = 8 -STANDBY HOT
Mode = Duplex
Unit = Primary
Unit ID = 1
Redundancy State = Stateful Switchover
Manual Swact = enabled
client count = 474
keep_alive TMR = 9000 milliseconds
keep_alive count = 1
keep_alive threshold = 18
RF debug mask = 0
Chapter 5
Slot = 1
Slot = 11
Configuring Virtual Switching Systems
OL-30933-01