Show Interfaces Rep Detail - Cisco Catalyst 3650 series Command Reference Manual

show interfaces rep detail

To display detailed REP configuration and status for all the interfaces or the specified interface, including the
administrative VLAN, use the show interfaces rep detail command in privileged EXEC mode.
show interfaces [interface-id] rep detail
Syntax Description
interface-id
Command Modes
Privileged EXEC (#)
Command History
Release
Cisco IOS XE Denali 16.2.2
Usage Guidelines
Enter this command on a segment edge port to send STCNs to one or more segments or to an interface. You
can verify your settings by entering the show interfaces rep detail privileged EXEC command.
Examples
The following example shows how to display the REP configuration and status for a specified interface.
Device#
TenGigabitEthernet4/1 REP enabled
Segment-id: 3 (Primary Edge)
PortID: 03010015FA66FF80
Preferred flag: No
Operational Link Status: TWO_WAY
Current Key: 02040015FA66FF804050
Port Role: Open
Blocked VLAN: <empty>
Admin-vlan: 1
Preempt Delay Timer: disabled
Configured Load-balancing Block Port: none
Configured Load-balancing Block VLAN: none
STCN Propagate to: none
LSL PDU rx: 999, tx: 652
HFL PDU rx: 0, tx: 0
BPA TLV rx: 500, tx: 4
BPA (STCN, LSL) TLV rx: 0, tx: 0
BPA (STCN, HFL) TLV rx: 0, tx: 0
EPA-ELECTION TLV rx: 6, tx: 5
EPA-COMMAND TLV rx: 0, tx: 0
EPA-INFO TLV rx: 135, tx: 136
(Optional) Physical interface used to display the port ID.
show interfaces TenGigabitEthernet4/1 rep detail
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
show interfaces rep detail
Modification
This command was introduced
339