Example 3 - Cisco BTS 10200 Troubleshooting Manual

Query Verification Tool and Translation Verification Tool

Example 3

In this example, the first TVT shows a translation but indicates that an LNP query is needed. The QVT
does not find an RN, so the first TVT has the correct translation and routing information.
btsadmin>translate line calling-dn=11501511; called-dn=11501512;
TRANSLATE ON CALL AGENT CA146 IS... ->
TABLEINFO ->
TABLE: SUBSCRIBER
ID=sipata1;CATEGORY=INDIVIDUAL;NAME=h15 sipata1
Moe;STATUS=ACTIVE;BILLING_DN=11501511;DN1=11501511;PRIVACY=NONE;RING_TYPE_DN1=1;PIC1=NONE;
PIC2=NONE;PIC3=NONE;GRP=N;USAGE_SENS=Y;SUB_PROFILE_ID=hungary_prof;TERM_TYPE=SIP;IMMEDIATE
_RELEASE=N;TERMINATING_IMMEDIATE_REL=N;AOR_ID=11501511@192.168.54.124;SEND_BDN_AS_CPN=N;SE
ND_BDN_FOR_EMG=N;PORTED_IN=N;BILLING_TYPE=NONE;VMWI=Y;SDT_MWI=Y;
TABLE: SUBSCRIBER_PROFILE
ID=hungary_prof;DIAL_PLAN_ID=dp_sub_itu;LOCAL_PFX1_OPT=NR;TOLL_PFX1_OPT=RQ;POP_ID=hun1;OLI
=0;EA_USE_PIC1=Y;INTERLATA_PFX1_OPT=RQ;
TABLE: SUBSCRIBER
ID=sipata2;CATEGORY=INDIVIDUAL;NAME=h15 sipata2
Larry;STATUS=ACTIVE;BILLING_DN=11501512;DN1=11501512;PRIVACY=NONE;RING_TYPE_DN1=1;PIC1=NON
E;PIC2=NONE;PIC3=NONE;GRP=N;USAGE_SENS=Y;SUB_PROFILE_ID=hungary_prof;TERM_TYPE=SIP;IMMEDIA
TE_RELEASE=N;TERMINATING_IMMEDIATE_REL=N;AOR_ID=11501512@192.168.54.124;SEND_BDN_AS_CPN=N;
SEND_BDN_FOR_EMG=N;PORTED_IN=N;BILLING_TYPE=NONE;VMWI=Y;SDT_MWI=Y;
****** LNP QUERY is needed (LNP-TRIGGER for ODBR), Suggested QUERY Command to Run ******
QUERY LNP;calling-dn=11501511;called-dn=11501512
****** If query result is Routing Number (RN) Not Found,
****** Otherwise, use the TRANSLATE command
Reply : Success:
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
15-36
.
.
.
the above translation is valid
suggested by the query result
Chapter 15 Diagnostic Tests
OL-8723-19