Cisco BTS 10200 Troubleshooting Manual page 752

Disaster Recovery From Flash Archive
Mark x on primary Disk and then Press Esc-2.
Step 31
Press Esc-2 to continue without preserve data.
Step 32
Press Esc-4 for Customize disk layout.
Step 33
Partition the disk as follows and Press Esc-2.
Step 34
filesys rootdisk.s0 2000 /
filesys rootdisk.s1 5000 /var
filesys rootdisk.s3 4000 swap
filesys rootdisk.s4 24
filesys rootdisk.s5 free /optfilesys rootdisk.s6 2000
Press Esc-2 to confirm Disk Layout.
Press Esc-2 to continue.
Step 35
Press Esc-2 to continue without remote mounts.
Step 36
Press Esc-2 to continue with installation.
Step 37
Note The restoration will take about 15-30 minutes.
Press ! (exclanation sign) to exit if prompted.
Step 38
Step 39 Verify /a/etc/vfstab and /a/etc/system files contain no disk mirroring information.
Example of /a/etc/vfstab:
######################################################
#device device mount FS fsck mount mount
#to mount to fsck point type pass at boot options
#
#/dev/dsk/c1d0s2 /dev/rdsk/c1d0s2 /usr ufs 1 yes -
fd - /dev/fd fd - no -
/proc - /proc proc - no -
/dev/dsk/c1t0d0s3 - - swap - no -
/dev/dsk/c1t0d0s0 /dev/rdsk/c1t0d0s0 / ufs 1 yes -
/dev/dsk/c1t0d0s1 /dev/rdsk/c1t0d0s1 /var ufs 1 yes -
/dev/dsk/c1t0d0s5 /dev/rdsk/c1t0d0s5 /opt ufs 2 yes -
swap - /tmp tmpfs - yes -
######################################################
/a/etc/system file SHOULD NOT have the following similar lines:
##############################
* Begin MDD root info (do not edit)
rootdev:/pseudo/md@0:0,2,blk
* End MDD root info (do not edit)
##############################
Enter the following command:
Step 40
cp /a/bin/date /a/bin/.date
mv /a/bin/date.archive /a/bin/date
mv /a/etc/rc3.d/S99platform /a/etc/rc3.d/saved.S99platform
Restore 2900 switch back to force 100MB full-duplex.
Step 41
Power cycle the system.
Step 42
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
16-4
Chapter 16 Disaster Recovery Procedures
OL-8723-19