Signaling (10) - Cisco BTS 10200 Troubleshooting Manual

Chapter 10 Signaling Troubleshooting

SIGNALING (10)

To troubleshoot and correct the cause of the alarm, refer to the
Initiation Protocol Message—Signaling (10)" section on page
DESCRIPTION Failed to Send Complete Session Initiation Protocol Message (Failed to Send Complete SIP Message)
SEVERITY MINOR
THRESHOLD 100
THROTTLE 0
DATAWORDS Destination Address–STRING [64]
PRIMARY Notifies the user that the Session Initiation Protocol (SIP) stack failed to send an SIP message due to
CAUSE it exceeding the maximum length of a UDP packet.
PRIMARY If encountered in normal network operations, the message should be captured on passive testing
ACTION equipment and sent to Cisco TAC for evaluation.
Refer to the
Note
detailed instructions on contacting Cisco TAC and opening a service request.
SIGNALING (11)
To troubleshoot and correct the cause of the alarm, refer to the
Protocol Control Block—Signaling (11)" section on page
DESCRIPTION Failed to Allocate Session Initiation Protocol Control Block (Failed to Allocate SIP Control Block)
SEVERITY MAJOR
THRESHOLD 100
THROTTLE 0
DATAWORDS Size–TWO_BYTES
Detail–STRING [80]
PRIMARY Issued when there is not enough memory to allocate a SIP call control block.
CAUSE
PRIMARY Increase the SIP call control block (CCB) count specified in mem.cfg file.
ACTION
SECONDARY Restart call agent for the changes to take effect.
ACTION
OL-8723-19
"Obtaining Documentation and Submitting a Service Request" section on page lvi
"Failed to Send Complete Session
10-132.
"Failed to Allocate Session Initiation
10-132.
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
Signaling Events and Alarms
for
10-7