Cisco Catalyst 4500 Series Configuration Manual page 499

Chapter 17 Configuring Layer 2 Ethernet Interfaces
Command
Step 3
Switch# show running-config interface
{fastethernet | gigabitethernet |
tengigabitethernet} slot/port
Step 4
Switch# show interfaces [{fastethernet |
gigabitethernet | tengigabitethernet} slot/port]
switchport
This example shows how to clear the Layer 2 configuration on the Fast Ethernet interface 5/6:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# default interface fastethernet 5/6
Switch(config)# end
Switch# exit
This example shows how to verify that the Layer 2 configuration was cleared:
Switch# show running-config interface fastethernet 5/6
Building configuration...
Current configuration:
!
interface FastEthernet5/6
end
This example shows how to verify the switch port configuration:
Switch# show interfaces fastethernet 5/6 switchport
Name: Fa5/6
Switchport: Enabled
Switch#
OL-25340-01
Configuring Ethernet Interfaces for Layer 2 Switching
Purpose
Displays the running configuration of the interface.
Displays the switch port configuration of the interface.
End with CNTL/Z.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
17-9