Cisco Catalyst 4500 Series Configuration Manual page 353

Chapter 9 Configuring Supervisor Engine Redundancy Using RPR and SSO on Supervisor Engine 6-E and Supervisor
To manipulate the redundant supervisor engine bootflash, perform one or more of the following
commands:
Command
Switch# dir slaveslot0:target_filename
or
Switch# dir slavebootflash:target_filename
Switch# delete slaveslot0:target_filename
or
Switch# delete slavebootflash:target_filename
Switch# squeeze slaveslot0:
or
Switch# squeeze slavebootflash:
Switch# format slaveslot0:
or
Switch# format slavebootflash:
Switch# copy source_device:source_filename
slaveslot0:target_filename
or
Switch# copy source_device:source_filename
slavebootflash:target_filename
OL-25340-01
Manipulating Bootflash on the Redundant Supervisor Engine
Purpose
Lists the contents of the slot0: device on the redundant
supervisor engine.
Lists the contents of the bootflash: device on the redundant
supervisor engine.
Deletes specific files from the slot0: device on the redundant
supervisor engine.
Deletes specific files from the bootflash: device on the
redundant supervisor engine.
Squeezes the slot0: device on the redundant supervisor
engine.
Squeezes the bootflash: device on the redundant supervisor
engine.
Formats the slot0: device on the redundant supervisor engine.
Formats the bootflash: device on the redundant supervisor
engine.
Copies a file from the active supervisor engine to the slot0:
device on the redundant supervisor engine.
Copies a file to the bootflash: device on a redundant
supervisor engine.
Source could be the active supervisor engine or a
Note
TFTP server.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
9-15