Cisco Catalyst 4500 Series Configuration Manual page 625

Chapter 24 Configuring EtherChannel and Link State Tracking
interface Port-channel2
switchport access vlan 10
switchport mode access
end
Switch#
The following two examples show how to verify the configuration of Fast Ethernet interface 5/6:
Switch# show running-config interface fastethernet 5/6
Building configuration...
Current configuration:
!
interface FastEthernet5/6
switchport access vlan 10
switchport mode access
channel-group 2 mode desirable
end
Switch# show interfaces fastethernet 5/6 etherchannel
Port state
Channel group = 1
Port-channel
Port indx
Flags:
Timers: H - Hello timer is running.
Local information:
Port
Fa5/6
Partner's information:
Port
Fa5/6
Age of the port in the current state: 00h:10m:57s
This example shows how to verify the configuration of port channel interface 2 after the interfaces have
been configured:
Switch# show etherchannel 2 port-channel
Port-channel: Po2
------------
Age of the Port-channel
Logical slot/port
GC
Port state
Ports in the Port-channel:
Index
-------------------
1
OL-25340-01
= EC-Enbld Up In-Bndl Usr-Config
Mode = Desirable
= Po1 GC
= 0 Load = 0x55
S - Device is sending Slow hello.
A - Device is in Auto mode.
d - PAgP is down.
S - Switching timer is running.
Flags State Timers
SC U6/S7
Partner
Name
JAB031301
Port-channels in the group:
----------------------
= 00h:23m:33s
= 10/2
= 0x00020001
= Port-channel Ag-Inuse
Load Port
00 Fa5/6
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Gcchange = 0
= 0x00010001
C - Device is in Consistent state.
P - Device learns on physical port.
Q - Quit timer is running.
I - Interface timer is running.
Hello Partner PAgP
Interval Count Priority
30s 1 128
Partner Partner
Device ID Port
0050.0f10.230c 2/47
Number of ports in agport = 2
HotStandBy port = null
Configuring EtherChannel
Learning Group
Method Ifindex
Any 56
Partner Group
Age Flags Cap.
18s SAC 2F
24-11