Cisco Catalyst 4500 Series Configuration Manual page 915

Chapter 40 Configuring Quality of Service
Class AutoQos-4.0-Default-Classify
The class maps used for Output matching are as follows:
! Since we assigned matched traffic to a qos-group on input,
! we only need to match the qos-group on output
! Note: Any other traffic not matched on input and assigned to a qos-group goes into the
class-default queue
! for control traffic (CS3 and AF31)
class-map match-all AutoQos-VoIP-Control-QosGroup24
match qos-group 24
class-map match-all AutoQos-VoIP-Control-QosGroup26
match qos-group 26
! For phone to phone (Bearer EF) traffic
class-map match-all AutoQos-VoIP-Bearer-QosGroup
match qos-group 46
! For softphone
Class Map match-any AutoQos-4.0-Scavenger-Queue (id 24)
Match qos-group 8
Match dscp cs1 (8)
Class Map match-all AutoQos-4.0-Priority-Queue (id 3)
Match qos-group 32
Class Map match-all AutoQos-4.0-Control-Mgmt-Queue (id 28)
Match qos-group 16
Class Map match-all AutoQos-4.0-Multimedia-Conf-Queue (id 10)
Match qos-group 34
Class Map match-all AutoQos-4.0-Multimedia-Stream-Queue (id 5)
Match qos-group 26
Class Map match-all AutoQos-4.0-Trans-Data-Queue (id 30)
Match qos-group 18
Class Map match-all AutoQos-4.0-Bulk-Data-Queue (id 17)
Match qos-group 10
The previous section listing defines the AutoQoS macros for defining QoS guidelines prior to Solution
Note
Reference Network Design 4.0 (SRND4). Starting with Cisco Release XE 3.3.0(SG) and 15.1(1)SG, the
Catalyst 4500 Series Switch supports the auto qos srnd4 command.
The following classes are required and generated by all SRND4 CLIs.
class-map match-all AutoQos-4.0-Priority-Queue
class-map match-all AutoQos-4.0-Control-Mgmt-Queue
class-map match-all AutoQos-4.0-Multimedia-Conf-Queue
OL-25340-01
set qos-group 8
set dscp default
set cos 0
match qos-group 32
match qos-group 16
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Configuring Auto-QoS
40-51