Cisco Catalyst 4500 Series Configuration Manual page 113

Command-Line Interfaces
This chapter describes the CLIs you use to configure the Catalyst 4500 series switch. This chapter
includes the following major sections:
Accessing the Switch CLI, page 2-2
•
• Performing Command-Line Processing, page 2-3
• Performing History Substitution, page 2-4
• About Cisco IOS Command Modes, page 2-4
• Getting a List of Commands and Syntax, page 2-5
• ROMMON Command-Line Interface, page 2-7
• Archiving Crashfiles Information, page 2-8
• Displaying a Crash Dump for Supervisor Engine 6-E and 6L-E, page 2-8
For complete syntax and usage information for the switch commands used in this chapter, first look at
Note
the Cisco Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If the command is not found in the Catalyst 4500 Series Switch Command Reference, it will be found in
the larger Cisco IOS library. Refer to the Cisco IOS Command Reference and related publications at
this location:
http://www.cisco.com/en/US/products/ps6350/index.html
The following command changes only apply to Supervisor Engines 6-E and 6L-E:
• The rename command is supported in the FAT file system for bootflash and slot0.
• The fsck command is supported for the slot0 device. It is not supported in the file systems on
supervisor engines other than Supervisor Engine 6-E and 6L-E.
The following additional file management commands are supported on Supervisor Engine 7-E and
Supervisor Engine 7L-E:
verify <filename>
•
delete <filename>
•
• copy <source_flename>, target_filename>
OL-25340-01
C H A P T E R
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
2
2-1