Default Vrf-Lite Configuration - Cisco Catalyst 4500 Series Configuration Manual

Chapter 39 Configuring VRF-lite
Figure 39-1
Figure 39-1
•
•
•
•
To configure VRF, create a VRF table and specify the Layer 3 interface associated with the VRF. You
then configure the routing protocols in the VPN and between the CE and the PE. BGP is the preferred
routing protocol used to distribute VPN routing information across the providers' backbone. The
VRF-lite network has three major components:
•
•
•

Default VRF-lite Configuration

Table 39-1
Table 39-1
Feature
VRF
Maps
OL-25340-01
Catalyst 4500 Series Switches Acting as Multiple Virtual CEs
VPN 1
CE
Catalyst 4500
Si
switch
VPN 2
illustrates the packet-forwarding process in a VRF-lite CE-enabled network.
When the CE receives a packet from a VPN, it looks up the routing table based on the input interface.
When a route is found, the CE forwards the packet to the PE.
When the ingress PE receives a packet from the CE, it performs a VRF lookup. When a route is
found, the router adds a corresponding MPLS label to the packet and sends it to the MPLS network.
When an egress PE receives a packet from the network, it strips the label and uses the label to
identify the correct VPN routing table. The egress PE then performs the normal route lookup. When
a route is found, it forwards the packet to the correct adjacency.
When a CE receives a packet from an egress PE, it uses the input interface to look up the correct
VPN routing table. If a route is found, the CE forwards the packet within the VPN.
VPN route target communities—Lists all other members of a VPN community. You need to
configure VPN route targets for each VPN community member.
Multiprotocol BGP peering of VPN community PE routers—Propagates VRF reachability
information to all members of a VPN community. You need to configure BGP peering in all PE
routers within a VPN community.
VPN forwarding—Transports all traffic between all VPN community members across a VPN
service-provider network.
shows the default VRF configuration.
Default VRF Configuration
Default Setting
Disabled. No VRFs are defined.
No import maps, export maps, or route maps are defined.
PE
MPLS
network
MPLS-VRF
router
CE = Customer edge device
PE = Provider edge router
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Default VRF-lite Configuration
CE
PE
Catalyst 4500
Si
switch
MPLS-VRF
router
VPN 1
VPN 2
39-3