Default Banner Configuration - Cisco Catalyst 4500 Series Configuration Manual

Creating a Banner

Default Banner Configuration

The MOTD and login banners are not configured.
Configuring a Message-of-the-Day Login Banner
You can create a single or multiline message banner that appears on the screen when someone logs in to
the switch.
To configure a MOTD login banner, perform this task:
Command
Step 1
configure terminal
Step 2
banner motd c message c
Step 3
end
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
4-18
Purpose
Enters global configuration mode.
Specifies the message of the day.
To delete the MOTD banner, use the no banner motd global
configuration command.
For c, enter the delimiting character of your choice, for example, a
pound sign (#), and press the Return key. The delimiting character
signifies the beginning and end of the banner text. Characters after the
ending delimiter are discarded.
When configuring a banner using the "#" sign as a delimeter on
Note
Supervisor Engine 7-E and Supervisor Engine 7L-E, you must
first turn off shell processing with the no shell processing
command. Else, you can not exit from the banner configuration.
### With shell processing enabled ###
Sup7# conf t
Enter configuration commands, one per line.
CNTL/Z.
Sup7(config)# ban
Sup7(config)# banner lo
Sup7(config)# banner login #
Enter TEXT message.
test login banner
#
##
e#
Sup7(config)#
### With shell processing disabled ###
Sup7(config)# banner login #
Enter TEXT message.
test login banner
#
Sup7(config)#
For message, enter a banner message up to 255 characters. You cannot
use the delimiting character in the message.
Returns to privileged EXEC mode.
Chapter 4 Administering the Switch
End with the character '#'
End with the character '#'
End with
OL-25340-01