Cisco Catalyst 4500 Series Configuration Manual page 429

Configuring the Catalyst 4500 Series Switch with
Cisco Network Assistant
This chapter describes how to install Network Assistant on the workstation and configure the Catalyst
4500 (or 4900) series switch to communicate with Network Assistant. (The term Catalyst 4500 series
switch will be used to refer to both switch types in this chapter.) It also describes how to create
communities and clusters, which are two technologies used by Network Assistant to manage a group of
network devices, including the Catalyst 4500 series switch.
For complete syntax and usage information for the switch commands used in this chapter, first look at
Note
the Cisco Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products//hw/switches/ps4324/index.html
If the command is not found in the Catalyst 4500 Series Switch Command Reference, it will be found in
the larger Cisco IOS library. Refer to the Cisco IOS Command Reference and related publications at this
location:
http://www.cisco.com/en/US/products/ps6350/index.html
This chapter contains these topics:
• About Network Assistant, page 14-2
• Network Assistant-Related Parameters and Their Defaults, page 14-3
Network Assistant CLI Commands, page 14-3
•
Configuring Your Switch for Network Assistant, page 14-4
•
Managing a Network Using Community, page 14-6
•
Converting a Cluster into a Community, page 14-10
•
Managing a Network Using Cluster, page 14-11
•
Configuring Network Assistant in Community or Cluster Mode, page 14-13
•
Note The Network Assistant is not bundled with an online software image on Cisco.com. You can download
the Network Assistant at this location:
http://www.cisco.com/en/US/products/ps5931/index.html
OL-25340-01
C H A P T E R
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
14
14-1