Cisco Catalyst 4500 Series Configuration Manual page 275

Release ios xe 3.3.0sg and ios 15.1(1)sg
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

Chapter 6
Configuring the Cisco IOS XE In Service Software Upgrade Process
This example shows how to initiate an ISSU upgrade process using the issu changeversion command on
slot number 5, the slot for the current active supervisor engine. The show issu state detail and show
redundancy command output is included to show the supervisor state before and after the upgrade
procedure.
Note
The success messages included in the output below is displayed after some delay because the ISSU
upgrade procedure progresses through the ISSU states.
Switch> enable
Switch# show issu state detail
Switch# show redundancy
Redundant System Information :
------------------------------
Switchovers system experienced = 0
Configured Redundancy Mode = Stateful Switchover
Current Processor Information :
------------------------------
Switch Software (cat4500e-UNIVERSALK9-M), Version 03.00.00.1.68 CISCO UNIVERSAL
DEVELOPMENT K10 IOSD TEST VERSION
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Sun 29-Aug-10 03:57 by gsbuprod
Peer Processor Information :
------------------------------
Switch Software (cat4500e-UNIVERSALK9-M), Version 03.00.00.1.68 CISCO UNIVERSAL
DEVELOPMENT K10 IOSD TEST VERSION
OL-25340-01
RP State = Active
ISSU State = Init
Operating Mode = Stateful Switchover
Current Image = bootflash:x.bin
Pre-ISSU (Original) Image = N/A
Post-ISSU (Targeted) Image = N/A
RP State = Standby
ISSU State = Init
Operating Mode = Stateful Switchover
Current Image = bootflash:x.bin
Pre-ISSU (Original) Image = N/A
Post-ISSU (Targeted) Image = N/A
Available system uptime = 12 minutes
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Operating Redundancy Mode = Stateful Switchover
Maintenance Mode = Disabled
Communications = Up
Active Location = slot 5
Current Software state = ACTIVE
Uptime in current state = 9 minutes
Image Version = Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3
Configuration register = 0x2920
Standby Location = slot 6
Current Software state = STANDBY HOT
Uptime in current state = 2 minutes
Image Version = Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3
Slot = 5
Slot = 6
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
How to Perform the ISSU Process
6-27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents