Cisco Catalyst 4500 Series Configuration Manual page 270

How to Perform the ISSU Process
The new active supervisor engine is now running the new version of software, and the standby supervisor
Note
engine is running the old version of software and is in the standby hot state.
Switch# show redundancy states
Redundancy Mode (Operational) = Stateful Switchover
Redundancy Mode (Configured) = Stateful Switchover
Communications = Up
client count = 64
client_notification_TMR = 240000 milliseconds
Once Runversion has completed, the new active supervisor engine will be running the new version of
software and the previously active supervisor engine will now become the standby supervisor engine.
The standby will be reset and reloaded, but it will remain on the previous version of software and come
back online in standbyhot status. The following example shows how to verify these conditions:
Switch# show redundancy
Redundant System Information :
------------------------------
Switchovers system experienced = 0
Configured Redundancy Mode = Stateful Switchover
Operating Redundancy Mode = Stateful Switchover
Current Processor Information :
------------------------------
Switch Software (cat4500e-UNIVERSALK9-M), Version 03.00.00.1.68 CISCO UNIVERSAL
DEVELOPMENT K10 IOSD TEST VERSION
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Sun 29-Aug-10 03:57 by gsbuprod
Peer Processor Information :
------------------------------
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
6-22
my state = 13 -ACTIVE
peer state = 8 -STANDBY HOT
Mode = Duplex
Unit = Primary
Unit ID = 6
Redundancy State = Stateful Switchover
Manual Swact = enabled
keep_alive TMR = 9000 milliseconds
keep_alive count = 0
keep_alive threshold = 18
RF debug mask = 0
Available system uptime = 12 minutes
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Maintenance Mode = Disabled
Communications = Up
Active Location = slot 6
Current Software state = ACTIVE
Uptime in current state = 9 minutes
Image Version = Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3
Configuration register = 0x2920
Standby Location = slot 5
Current Software state = STANDBY HOT
Uptime in current state = 2 minutes
Chapter 6 Configuring the Cisco IOS XE In Service Software Upgrade Process
OL-25340-01