Table of Contents
Advertisement
Bit 2:
PV
Description
0
Program-verify mode cleared
1
Transition to program-verify mode
[Setting condition]
When FWE = 1, and SWE = 1
1,
Bit 1—Erase (E) *
EV, PV, or P bit at the same time.
Bit 1:
E
Description
0
Erase mode cleared
1
Transition to erase mode
[Setting condition]
When FWE = 1, SWE = 1, and ESU = 1
Bit 0—Program (P) *
ESU, PSU, EV, PV, or E bit at the same time.
Bit 0:
P
Description
0
Program mode cleared
1
Transition to program mode
[Setting condition]
When FWE = 1, SWE = 1, and PSU = 1
Notes: 1. Do not set two or more bits at the same time.
Do not turn off V
2. Do not set/clear the SWE bit simultaneously with other bits (ESU, PSU, EV, PV, E, P).
3. Set the P and E bits according to the program and erase algorithms shown in section
15.5, Programming and Erasing Flash Memory.
For the usage precautions, see section 15.9, Notes on Flash Memory
Programming/Erasing.
444
3
*
: Selects erase mode transition or clearing. Do not set the SWE, ESU, PSU,
1,
3
*
: Selects program mode transition or clearing. Do not set the SWE,
when a bit is set.
CC
(Initial value)
(Initial value)
(Initial value)
Advertisement
Table of Contents
