Table of Contents
Advertisement
• The parameter H Multi determines the number of pattern replications
horizontally, and the parameter V Multi determines the number of pattern
replications vertically.
• The parameter Shift determines the manner of replication.
At a value of –100.00, the pattern of the adjacent odd-numbered column on
the left lines up with the central coordinate horizontally.
At a value of +100.00, the pattern of the adjacent odd-numbered column on
the right lines up with the central coordinate horizontally.
For an independent key transition wipe, you can use the "Invert Type"
parameter to select from the following four types of replication pattern.
1: All replications in the same orientation
2: Even-numbered rows staggered
3: Even-numbered columns and rows inverted
4: Even-numbered columns and rows inverted, and even-numbered rows
staggered
Pairing
This slits the pattern into multiple strips, making it like a venetian blind.
H: Create slits in the horizontal direction.
V: Create slits in the vertical direction.
• The parameter Width determines the width of the slits.
• The parameter H Offset determines the spacing in the horizontal direction.
If a negative value is set, the even-numbered pairs of strip and slit move to
the left, and the odd-numbered pairs move to the right. The value –100.00
represents the maximum movement.
If a positive value is set, the even-numbered pairs of strip and slit move to
1
2
Pairing off
3
4
Pairing on
63
Wipes
Advertisement
Table of Contents
